This bar loader was purchased as a Demo Unit but never installed
          
          Replacement cost about $19K
          
          
          TECHNICAL SPECIFICATION from Manual
          
          Scope of application Bar dimension
              Bar round cross section:                6 to 80 mm
              Bar hexagonal cross section:            8 to 68 mm
              Bar square cross section:               8 to 55 mm
          Bar weight
              Maximum weight of the loaded bar:       60 kg
          Bar length
              Maximum length of the bar:              1525 mm
          Magazine capacity depending on the bar diameter
              8 bars:                                 80 mm
              The # of bars limited by the table cap   6 mm
          Max Weight of all bars on Table:            250 kg
          Pusher stroke
              Design stroke:                          1665 mm
              Working stroke:                         1660 mm
              Max dist of the clamping device face    1655 mm
              from the pusher point in back position
          Technology of bar handling
              The bar is cantered in the lathe spindle by spindle inserts, and shifted
          
              by the pusher to a stopper in the tool head.
          Bar loading cycle:                          approx. 30 s
          Setting time at change of bar diameter:      Max. 1 minute at change diameter
                                                       + time of lathe spindle insert
          
                                                      replacement
          Electrical equipment
          Power supply:                               200/230/400 VAC, 50/60 Hz, 320 VA
          Power circuits:                             200 VAC, 24 VDC
          Logic circuits:                             24 VDC
          Weight:                                     approx. 375 kg
          Transport dimensions:                       L 2230 x W 1150 x H 1220 mm
          
          
          CONCEPT
          The barfeeder ML-565/580 T/S is a powerful machine with a long service life
          
          and minimal maintenance required. Its operation and functions are simple which
          
          facilitates the work even to less skilled workers.
          
          The barfeeder is controlled by means of the control panel in the right part of
          
          the machine. There is an E-Stop pushbutton for emergency stop on the control
          
          panel. In the left part of the barfeeder frame there is a Q1 switch.
          Bars are loaded in the magazine. Loading of bars into the lathe is ensured by
          
          a loading channel with a flag and pusher.
          
          On the rear side of the frame there are connectors X1, X2 for barfeeder
          
          interconnection with the lathe.
          
          
          Currently configured for a Mazak QTN250 MSY
          
          
          
          
          

Automatics & Machinery Co Inc
150 Martin St Longmont CO 80501-5939
Tel: 800-543-7666 Fax: 303-651-6556
Email (Request Quote): kristen@automatics.com
Web: www.automatics.com